INSPECTION
Inspection · Vehicles built from Oct 2014
| INSPECT CHARCOAL CANISTER ASSEMBLY |
Check the appearance.
Visually check the charcoal canister assembly for cracks or damage.
If necessary, replace the charcoal canister assembly.
Check the charcoal canister filter.
Detach the 2 claws and remove the charcoal canister filter.

Text in Illustration *1
Charcoal Canister Filter
*a
Claw
Visually check that the charcoal canister filter is not excessively damaged or dirty.

If necessary, replace the charcoal canister assembly.Text in Illustration *1
Charcoal Canister Filter
Check the charcoal canister operation.
Blow air (4.7 kPa (0.05 kgf/cm2, 0.7 psi)) into port A, then check that the air flows from ports B and C.

If the ventilation is not as specified, replace the charcoal canister assembly.Text in Illustration *a
Port A
*b
Port B
*c
Port C


Air
Clean the filter in canister.
Clean the filter by blowing (19.6 kpa (0.2 kgf/cm2, 2.8 psi)) compressed air into port B while holding port A closed.

Text in Illustration *a
Port A
*b
Port B
*c
Port C


Air
- NOTICE:
- Do not attempt to wash the charcoal canister assembly.
- No activated carbon should come out.
- Do not attempt to wash the charcoal canister assembly.
Install the charcoal canister filter.
