2014-2019 Hiace · Service Manual HEATER & AIR CONDITIONING SYSTEM

REMOVAL

Removal / installation · Vehicles built from Oct 2014


1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. Turn the A/C switch on.

  1. Operate the cooler compressor at an engine rpm of approximately 1,000 for 5 to 6 minutes to circulate the refrigerant and collect compressor oil remaining in each component into the cooler compressor as much as possible.

  1. Stop the engine.

  1. Using SST, let the refrigerant gas out.

    SST
    07110-58060   (07117-58080, 07117-58090, 07117-78050, 07117-88060, 07117-88070, 07117-88080)


2. REMOVE FRONT BUMPER COVER (for Standard Body)
(Click here)

3. REMOVE FRONT BUMPER COVER (for Wide Body)
(Click here)

4. REMOVE HOOD LOCK SUPPORT BRACE SUB-ASSEMBLY

  1. E289333E01
    Remove the 3 bolts and hood lock support brace sub-assembly.
    Text in Illustration 
    *A
    for Standard Body
    *B
    for Wide Body


5. REMOVE FRONT FLOOR CROSS MEMBER REINFORCEMENT SUB-ASSEMBLY RH (for Standard Body)

  1. B366605
    Remove the 5 bolts and front floor crossmember reinforcement sub-assembly RH.


6. REMOVE FRONT FLOOR CROSS MEMBER REINFORCEMENT SUB-ASSEMBLY RH (for Wide Body)

B366604
  1. Remove the 5 bolts and front floor crossmember reinforcement sub-assembly RH.


7. REMOVE FRONT BUMPER REINFORCEMENT

  1. B260285
    Remove the 6 bolts and front bumper reinforcement.


8. REMOVE FRONT BUMPER REINFORCEMENT (for Wide Body)

  1. B260285
    Remove the 6 bolts and front bumper reinforcement.


9. DISCONNECT COOLER REFRIGERANT DISCHARGE PIPE A

  1. E103899
    Remove the bolt and disconnect the cooler refrigerant discharge pipe A from the cooler condenser assembly.

  1. Remove the O-ring from the cooler refrigerant discharge pipe A.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.


10. DISCONNECT COOLER REFRIGERANT LIQUID PIPE A

  1. E103900
    Remove the bolt and clamp.

  1. E103901
    Remove the bolt and disconnect the cooler refrigerant liquid pipe A from the cooler condenser assembly.

  1. Remove the O-ring from the cooler refrigerant liquid pipe A.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.


11. REMOVE W/ RECEIVER CONDENSER ASSEMBLY

  1. E103902
    Remove the 4 bolts and w/ receiver condenser assembly.

← ON-VEHICLE INSPECTION (from Oct 2014)DISASSEMBLY (from Oct 2014) →