2014-2019 Hiace · Service Manual STEERING

INSTALLATION

Removal / installation · Vehicles built from Oct 2014


1. INSTALL VANE PUMP ASSEMBLY

  1. C106135E01
    Install the vane pump assembly with the 2 bolts and the nut.

    Torque:
    Bolt (A):
    48 N*m{ 490 kgf*cm , 35 ft.*lbf }
    Nut (C):
    63 N*m{ 642 kgf*cm , 47 ft.*lbf }

    HINT:
    Turn nut (C) while holding bolt (B).


2. INSTALL VANE PUMP PULLEY

  1. C106134E01
    Using SST, install the vane pump pulley to the vane pump assembly.
    SST
    09960-10010   (09962-01000, 09963-01000)

    Torque:
    43 N*m{ 439 kgf*cm , 32 ft.*lbf }


3. CONNECT PRESSURE FEED TUBE ASSEMBLY
  1. Install a new gasket to the pressure feed tube assembly.

  1. C106132
    Connect the pressure feed tube assembly to the vane pump assembly with the union bolt.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }

    HINT:
    Make sure the stopper of the pressure feed tube assembly touches the vane pump assembly.


4. CONNECT OIL RESERVOIR TO PUMP HOSE NO.1

  1. C106131
    Connect the oil reservoir to pump hose No.1 to the vane pump assembly with the clip.


5. INSTALL FAN & GENERATOR V BELT

  1. A071310E01
    Install the V belt.

  1. Using a bar, adjust the tension of the V-ribbed belt.

  1. Tighten the bolt A and nut B.

    Torque:
    Bolt (A):
    48 N*m{ 489 kgf*cm , 35 ft.*lbf }
    Nut (B):
    64 N*m{ 635 kgf*cm , 47 ft.*lbf }

  1. Check the tension of the V belt. (Click here)


6. ADD POWER STEERING FLUID

7. BLEED POWER STEERING FLUID
(Click here)

8. CHECK FOR POWER STEERING FLUID LEAKS
← REASSEMBLY (from Oct 2014)COMPONENTS (from Oct 2014) →