2014-2019 Hiace · Service Manual STEERING

INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT VANE PUMP SHAFT AND BUSHING IN FRONT VANE PUMP HOUSING

  1. F009875E01
    Using a micrometer and vernier calipers, measure the oil clearance.

    Maximum oil clearance:
    0.07 mm (0.0028 in.)

    If oil clearance exceeds the maximum, replace the vane pump assembly.


INSPECT VANE PUMP ROTOR AND VANE PUMP PLATES

  1. C101977
    Using a micrometer, measure the thickness of the vane pump plates.

    Standard thickness:
    1.405 to 1.411 mm (0.05531 to 0.05555 in.)

  1. C101978
    Using a feeler gauge, measure the clearance between a side face of the vane pump rotor groove and the vane pump plates.

    Maximum clearance:
    0.03 mm (0.0012 in.)

    If clearance exceeds the maximum, replace the vane pump assembly.


INSPECT FLOW CONTROL VALVE

  1. G030668E01
    Coat the flow control valve with power steering fluid and check that it falls smoothly into the flow control valve hole under its own weight.
    If it lacks smoothness, replace the vane pump assembly.

  1. R007591E01
    Check the flow control valve for leakage. Close one of the holes and apply compressed air, 392 to 490 kPa (4 to 5 kgf/cm2, 57 to 71 psi), into the opposite side hole, and confirm that air does not come out from the end holes.
    If air leaks, replace the vane pump assembly.


INSPECT FLOW CONTROL VALVE COMPRESSION SPRING

  1. R008702E02
    Using vernier calipers, measure the free length of the flow control valve compression spring.

    Minimum free length:
    29.2 mm (1.150 in.)

    If the length is less than the minimum, replace the vane pump assembly.


INSPECT PRESSURE PORT UNION

HINT:
If the union seat in the pressure port union is severely damaged, it may cause fluid leakage. In that case, replace the vane pump assembly.


INSPECT TOTAL PRELOAD
  1. Check that the pump rotates smoothly without abnormal noise.

  1. Temporarily install the service bolt.

    Recommended service bolt:
    Thread diameter:
    10 mm (0.39 in.)
    Thread pitch:
    1.25 mm (0.0492 in.)
    Bolt length:
    50 mm (1.97 in.)

  1. C053369E02
    Using a torque wrench, check the rotating torque.

    Rotating torque:
    0.27 N*m (2.8 kgf*cm , 2.4 in.*lbf) or less

    If rotating torque is not as specified, check the installation condition of each part.

← DISASSEMBLY (from Oct 2014)REASSEMBLY (from Oct 2014) →