2014-2019 Hiace · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Oct 2014


1. INSTALL EXHAUST PIPE ASSEMBLY TAIL

2. INSTALL EXHAUST PIPE ASSEMBLY CENTER
  1. Install a new gasket to the exhaust pipe assembly center.

  1. Connect the exhaust pipe assembly center to the exhaust pipe supports.

  1. Install the exhaust pipe assembly center and exhaust pipe assembly tail with the 2 bolts.

    Torque:
    48 N*m{ 489 kgf*cm , 35 ft.*lbf }


3. INSTALL EXHAUST PIPE ASSEMBLY FRONT
  1. w/ Secondary air injection system:

    1. Install the air fuel ratio sensor. (Click here)

      Torque:
      44 N*m{ 449 kgf*cm , 32 ft.*lbf }

  1. For Unleaded gasoline engine:

    1. Install the oxygen sensor. (Click here)

      Torque:
      44 N*m{ 449 kgf*cm , 32 ft.*lbf }

  1. Inspect the compression spring.

    1. A077857
      Using vernier calipers, measure the free length of the compression springs.

      Minimum length:
      40.5 mm (1.594 in.)

      HINT:
      If the free length is less than the minimum, replace the compression spring.

  1. A102062E03
    Install the gasket.

    1. Fully insert a new gasket to the exhaust manifold by hand.

    2. Using a wooden block, uniformly strike the gasket so that the gasket and exhaust manifold are properly fit.

      NOTICE:
      1. Be careful with the installation direction of the gasket.
      2. Do not reuse the gasket.
      3. Do not damage the gasket.
      4. To ensure a proper seal, do not use the exhaust pipe assembly front to force the gasket onto the exhaust manifold.

    3. Install a new gasket to the exhaust pipe assembly front.

    4. Connect the exhaust pipe assembly front to the exhaust pipe support.

    5. Install the exhaust pipe assembly front with the 4 bolts, 2 nuts, and 2 compression springs.

      Torque:
      Exhaust manifold side:
      43 N*m{ 438 kgf*cm , 32 ft.*lbf }
      Exhaust pipe assembly center side:
      48 N*m{ 489 kgf*cm , 35 ft.*lbf }

      NOTICE:
      After installation, check that the clearance is almost the same at any point between the flanges of the exhaust manifold and exhaust pipe assembly front.

  1. For Unleaded gasoline engine:

    1. Connect the sensor connector(s).


4. CHECK FOR EXHAUST GAS LEAKS
← REMOVAL (from Oct 2014)ON-VEHICLE INSPECTION (from Oct 2014) →