2014-2019 Hiace · Service Manual DRIVE LINE

REMOVAL

Removal / installation · Vehicles built from Oct 2014


1. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

  1. C102185E01
    Put matchmarks on both flanges.

  1. Remove the 4 nuts, bolts and washers.

    HINT:
    If the flange connection is hard to separate, temporarily tighten one nut only and evenly tap the flange with a brass bar and hammer to separate the propeller with center bearing shaft assembly from the differential companion flange.

  1. C107214
    Remove the 2 bolts and center support bearing assembly No.1.

  1. Remove the propeller with center bearing shaft assembly.

  1. C102186E01
    Insert SST in the transmission to prevent oil leakage.

    NOTICE:
    Do not damage the oil seal.


    1. Use the following SST for the automatic transmission.

      SST
      09325-40010  

    2. Use the following SST for the manual transmission.

      SST
      09325-20010  

← COMPONENTS (from Oct 2014)DISASSEMBLY (from Oct 2014) →