2014-2019 Hiace · Service Manual BRAKE

TC and CG Terminal Circuit

Circuit diagnosis · Vehicles built from Oct 2014

DESCRIPTION

DTC output mode is set by connecting terminals TC and CG of the DLC3.
The DTCs are displayed by the blinking pattern of the ABS warning light.

WIRING DIAGRAM

C109400E03

HINT:
When warning lights continue to blink, a ground short in the wiring of terminal TC of the DLC3 or an internal ground short in one or more ECU is suspected.


INSPECTION PROCEDURE


1. INSPECT DLC3 (BETWEEN DLC3 (TC) AND DLC3 (CG))

  1. C052361E48
    Turn the ignition switch to the ON position.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Specified Condition
    H23-13 (TC) - H23-4 (CG)
    10 to 14 V



NG
Go to step 3
OK


2. CHECK HARNESS AND CONNECTOR (BETWEEN SKID CONTROL ECU AND DLC3 (TC))

  1. C111163E01
    Turn the ignition switch off.

  1. Disconnect the skid control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    B19-16 (TC) - H23-13 (TC)
    Below 1 Ω
    B19-16 (TC) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE BRAKE ACTUATOR ASSEMBLY

3. CHECK HARNESS AND CONNECTOR (BETWEEN DLC3 (CG) AND BODY GROUND)

  1. C052361E51
    Turn the ignition switch off.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    H23-4 (CG) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK HARNESS AND CONNECTOR (BETWEEN SKID CONTROL ECU AND DLC3 (TC))

  1. C111163E01
    Disconnect the skid control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    B19-16 (TC) - H23-13 (TC)
    Below 1 Ω
    B19-16 (TC) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE BRAKE ACTUATOR ASSEMBLY


← ABS Warning Light does not Come ON (from Jan 2017)TS and CG Terminal Circuit (from Oct 2014) →