2014-2019 Hiace · Service Manual BRAKE

TS and CG Terminal Circuit

Circuit diagnosis · Vehicles built from Oct 2014

DESCRIPTION

The Test Mode (signal check) circuit detects trouble in the sensor or switch signal, which cannot be detected by the DTC check.
Connecting terminals TS and CG of the DLC3 starts the check.

WIRING DIAGRAM

C109400E04

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (BETWEEN SKID CONTROL ECU AND DLC3 (TS))

  1. C111163E02
    Turn the ignition switch off.

  1. Disconnect the skid control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    B19-15 (TS) - H23-12 (TS)
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK HARNESS AND CONNECTOR (BETWEEN DLC3 (CG) AND BODY GROUND)

  1. C052361E51
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    H23-4 (CG) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. CHECK HARNESS AND CONNECTOR (BETWEEN DLC3 (TS) AND BODY GROUND)

  1. C052361E53
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Specified Condition
    H23-12 (TS) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE BRAKE ACTUATOR ASSEMBLY


← TC and CG Terminal Circuit (from Oct 2014)PRECAUTION (from Jan 2015) →