2014-2019 Hiace · Service Manual BRAKE

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Jan 2015

Versions by build date: Oct 2014 – Dec 2014 from Jan 2015

  1. The anti-lock brake system troubleshooting procedures are based on the premise that the CAN communication system is functioning normally. Check the CAN communication system first before troubleshooting the anti-lock brake system.
  2. *: Use the GTS.

1.VEHICLE BROUGHT TO WORKSHOP
    NEXT

    2.CUSTOMER PROBLEM ANALYSIS
    1. Interview the customer to confirm the trouble.

    NEXT

    3.CHECK DTC AND FREEZE FRAME DATA*
    1. Check and record DTC and freeze frame data.

    2. Clear the DTC and freeze frame data.

    3. Reconfirm the DTC.

      1. Reconfirm the DTC based on the recorded DTC and freeze frame data.

        Result:
        Result
        Proceed to
        DTC is output
        A
        DTC is not output (Problem symptom does not occur)
        B
        DTC is not output (Problem symptom occurs)
        C


    B.

    C.
    A

    4.DIAGNOSTIC TROUBLE CODE CHART
    1. Proceed to Diagnostic Trouble Code Chart.

    NEXT

    5.SYMPTOM SIMULATION
    1. Proceed to Check for Intermittent Problems.

    NEXT

    6.PROBLEM SYMPTOMS TABLE
    1. Proceed to Problem Symptoms Table.

    NEXT

    7.CIRCUIT INSPECTION
      NEXT

      8.IDENTIFICATION OF PROBLEM
        NEXT

        9.REPAIR OR REPLACE
          NEXT

          10.CONFIRMATION TEST*
            NEXT

            ← HOW TO PROCEED WITH TROUBLESHOOTING (Oct 2014 – Dec 2014)CHECK FOR INTERMITTENT PROBLEMS (Oct 2014 – Dec 2014) →