2014-2019 Hiace · Service Manual BRAKE

CHECK FOR INTERMITTENT PROBLEMS

Troubleshooting · Vehicles built Oct 2014 – Dec 2014

Versions by build date: Oct 2014 – Dec 2014 from Jan 2015


CHECK FOR INTERMITTENT PROBLEMS

HINT:
A momentary interruption (open circuit) in the connectors and/or wire harness between the sensors and ECUs can be detected in the ECU data monitor function of the intelligent tester.

  1. C112604E01
    Turn the ignition switch off and connect the intelligent tester to the DLC3.

  2. C106657E03
    Turn the ignition switch to the ON position. Follow the directions on the intelligent tester to display the DATA LIST and select areas where momentary interruption should be monitored.

    HINT:
    A momentary interruption (open circuit) cannot be detected for 3 seconds after the ignition switch is turned on (initial check).

    Item (Display)
    Measurement Item / Range (Display)
    Normal Condition
    Diagnostic Note
    FR Speed Open
    Speed sensor open detection (FR) / OPN DET or NORMAL
    OPN DET: Momentary interruption
    NORMAL: Normal
    -
    FL Speed Open
    Speed sensor open detection (FL) / OPN DET or NORMAL
    OPN DET: Momentary interruption
    NORMAL: Normal
    -
    RR Speed Open
    Speed sensor open detection (RR) / OPN DET or NORMAL
    OPN DET: Momentary interruption
    NORMAL: Normal
    -
    RL Speed Open
    Speed sensor open detection (RL) / OPN DET or NORMAL
    OPN DET: Momentary interruption
    NORMAL: Normal
    -

    HINT:
    1. If the intelligent tester status remains on, check the continuity between the ECU and the sensors, or between ECUs.
    2. The OPN DET display on the intelligent tester remains on for 1 second after the harness signal changes from momentary interruption (open circuit) to normal condition.

  3. F047126E02
    While observing the screen, gently jiggle the connector or wire harness between the ECU and sensors, or between ECUs.

    Result:
    OPN DET display does not change.

    HINT:
    The connector and/or wire harness will be in momentary interruption (open circuit) if the display changes. Repair or replace the connector and/or wire harness as one of them is faulty.

← HOW TO PROCEED WITH TROUBLESHOOTING (from Jan 2015)CHECK FOR INTERMITTENT PROBLEMS (from Jan 2015) →