2014-2019 Hiace · Service Manual BRAKE

CHECK FOR INTERMITTENT PROBLEMS

Troubleshooting · Vehicles built from Jan 2015

Versions by build date: Oct 2014 – Dec 2014 from Jan 2015


CHECK FOR INTERMITTENT PROBLEMS

HINT:
A momentary interruption (open circuit) in the connectors and/or wire harnesses between the sensors and ECUs can be detected using the ECU Data List function of the GTS.

  1. Turn the ignition switch off.

  2. Connect the GTS to the DLC3.

  3. Turn the ignition switch to ON.

  4. Turn the GTS on.

  5. Follow the directions on the GTS to display the Data List and select areas where momentary interruptions should be monitored.

    HINT:
    1. A momentary interruption (open circuit) cannot be detected for 3 seconds after the ignition switch is turned to ON (initial check).
    2. If the Error display remains displayed, measure the resistance between the ECUs and sensors, or between ECUs.
    3. The Error display on the GTS will remain displayed for 1 second after the harness signal changes from momentary interruption (open circuit) to the normal condition.

    ABS/VSC/TRC 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    FR Speed Open
    Front speed sensor RH open detection / Error or Normal
    Normal
    Error: Momentary interruption
    FL Speed Open
    Front speed sensor LH open detection / Error or Normal
    Normal
    Error: Momentary interruption
    RR Speed Open
    Rear speed sensor RH open detection / Error or Normal
    Normal
    Error: Momentary interruption
    RL Speed Open
    Rear speed sensor LH open detection / Error or Normal
    Normal
    Error: Momentary interruption
    IG Voltage Value Decreased
    IG voltage value decrease detection / Error or Normal
    Normal
    Error: Momentary interruption
    IG Voltage Value Increased
    IG voltage value increase detection / Error or Normal
    Normal
    Error: Momentary interruption
    FR Speed Sensor Voltage Open
    Front speed sensor RH voltage open detection / Error or Normal
    Normal
    Error: Momentary interruption
    FL Speed Sensor Voltage Open
    Front speed sensor LH voltage open detection / Error or Normal
    Normal
    Error: Momentary interruption
    RR Speed Sensor Voltage Open
    Rear speed sensor RH voltage open detection / Error or Normal
    Normal
    Error: Momentary interruption
    RL Speed Sensor Voltage Open
    Rear speed sensor LH voltage open detection / Error or Normal
    Normal
    Error: Momentary interruption

  6. While observing the screen, gently jiggle the connector or wire harness between the ECU and sensors, or between ECUs.

    OK:
    Normal is displayed.

    HINT:
    If the display changes, the connector and/or the wire harness has caused a momentary interruption of the circuit. Repair or replace the connector and/or wire harness as one of them is faulty.

← CHECK FOR INTERMITTENT PROBLEMS (Oct 2014 – Dec 2014)TEST MODE PROCEDURE (Oct 2014 – Dec 2014) →