2014-2019 Hiace · Service Manual ENGINE

P161A LIN Communication Error with Alternator

Diagnostic trouble codes · Vehicles built from Jan 2017

DESCRIPTION

The ECM and generator assembly each detect reception malfunctions. A generator assembly reception malfunction detected by the generator assembly is sent to the ECM via LIN communication. If there is a malfunction in either the ECM or generator assembly, the ECM determines that there is a LIN communication malfunction and outputs a DTC.
DTC Code
DTC Detection Condition
Trouble Area
P161A
Diagnosis condition:
Ignition switch ON
When the ECM cannot receive LIN communication, the generator assembly cannot receive LIN communication for approximately 17 minutes or more
Other: 1 trip
  1. Harness or connector
  2. Generator assembly
  3. ECM

WIRING DIAGRAM

E221308E17

INSPECTION PROCEDURE


1. CHECK CHARGING SYSTEM
  1. Check the charging system (Click here).



NG
REPAIR OR REPLACE CHARGING SYSTEM
OK


2. CHECK HARNESS AND CONNECTOR (ECM - GENERATOR ASSEMBLY)
  1. Disconnect the ECM connector.

  1. Disconnect the generator assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    D134-61 (LIN) - D23-2 (LIN)
    Always
    Below 1 Ω
    D134-61 (LIN) or D23-2 (LIN) - Body ground
    Ignition switch off (while LIN communication is stopped)
    10 kΩ or higher

  1. Reconnect the generator assembly connector.

  1. Reconnect the ECM connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT GENERATOR ASSEMBLY
  1. Inspect the generator assembly (Click here).



NG
REPLACE GENERATOR ASSEMBLY (Click here)
OK

REPLACE ECM (Click here)


← ON-VEHICLE INSPECTION (from Jan 2017)Charging Failure (from Jan 2017) →