2014-2019 Hiace · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Jan 2017


INSPECT GENERATOR WITH CLUTCH PULLEY

  1. A222451
    Hold the center of the generator pulley with clutch and check that the outer ring turns counterclockwise and does not turn clockwise.
    Text in Illustration 
    V100135
    Free
    V100136
    Lock
    If the result is not as specified, replace the generator pulley with clutch.


INSPECT GENERATOR BRUSH HOLDER ASSEMBLY

  1. A128079E19
    Using a vernier caliper, measure the exposed brush length.

    Standard exposed length:
    9.5 to 11.5 mm (0.374 to 0.453 in.)

    Minimum exposed length:
    4.5 mm (0.177 in.)

    Text in Illustration 
    *a
    Length
    If the exposed brush length is less than the minimum, replace the generator brush holder assembly.


INSPECT GENERATOR ROTOR ASSEMBLY

  1. A079306E02
    Check that the generator rotor bearing is not rough or worn and that it rotates smoothly.
    If necessary, replace the generator rotor assembly.

  1. Check the generator rotor assembly for an open circuit.

    1. A153720E01
      Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      Slip ring - Slip ring
      20°C (68°F)
      1.6 to 2.0 Ω

      Text in Illustration 
      *a
      Slip Ring
      If the result is not as specified, replace the generator rotor assembly.

  1. Check the generator rotor assembly for a short to ground.

    1. A153814E01
      Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      Slip ring - Rotor core
      Always
      10 MΩ or higher

      Text in Illustration 
      *a
      Slip Ring
      *b
      Rotor Core
      If the result is not as specified, replace the generator rotor assembly.

  1. Check each slip ring.

    1. Check that the slip rings are not rough or scored.
      If the slip rings are rough or scored, replace the generator rotor assembly.

    2. A182587E01
      Using a vernier caliper, measure the slip ring diameter.

      Standard diameter:
      14.2 to 14.8 mm (0.559 to 0.583 in.)

      Minimum diameter:
      14.0 mm (0.551 in.)

      Text in Illustration 
      *a
      Diameter
      If the diameter is less than the minimum, replace the generator rotor assembly.

← DISASSEMBLY (from Jan 2017)REASSEMBLY (from Jan 2017) →