2014-2019 Hiace · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built Oct 2014 – Nov 2017

Versions by build date: Oct 2014 – Nov 2017 from Dec 2017


CHECK ENGINE OIL LEVEL
  1. Warm up the engine, stop the engine and wait for 5 minutes. The oil level should be between the low and full level marks of the dipstick.
    If low, check for leakage and add oil up to the full level mark.

    NOTICE:
    Do not fill the engine oil above the full level mark.


CHECK ENGINE OIL QUALITY

  1. A113813E01
    Check the oil for deterioration, water contamination, discoloring or thinning.
    If the quality is visibly poor, replace the oil.

    HINT:
    TOYOTA Genuine Motor Oil is in this vehicle when it is shipped. Use TOYOTA approved TOYOTA Genuine Motor Oil or equivalent to satisfy the following grade and viscosity.

    Oil grade:
    G-DLD1 or API grade CF-4, CF (API CE or CD may also be used)

    If using SAE 10W-30 or a higher viscosity engine oil in extremely low temperatures, the engine may become difficult to start.
    For low temperatures SAE 5W-30 engine oil is recommended.


CHECK ENGINE OIL PRESSURE

  1. A102290E01
    Disconnect the oil pressure switch connector.

  1. Remove the oil pressure switch.

  1. Install the oil pressure gauge.

  1. Warm up the engine.

  1. Measure the oil pressure.

    Oil pressure:
    Condition
    Specified Condition
    Idle
    29 kPa (0.3 kgf/cm2, 4.2 psi) or more
    3,000 rpm
    245 kPa (2.5 kgf/cm2, 36 psi) or more

    If the oil pressure is not as specified, check the oil pump (Click here).

  1. Remove the oil pressure gauge.

  1. G036762E02
    Apply adhesive to 2 or 3 threads of the oil pressure switch.

    Adhesive:
    Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

  1. Install the oil pressure switch.

    Torque:
    15 N*m{ 153 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Do not start the engine for at least 1 hour after installation of the switch.

  1. Connect the oil pressure switch connector.

  1. Start the engine and check for engine oil leaks.

← INSTALLATION (from Jan 2017)ON-VEHICLE INSPECTION (from Dec 2017) →