2014-2019 Hiace · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Oct 2014


CHECK OIL QUALITY
  1. Check the oil for deterioration, water contamination, discoloration or thinning.
    If the oil is visibly poor, replace the oil and oil filter.


CHECK OIL LEVEL
  1. Warm up the engine, stop the engine and wait for 5 minutes.

  1. Check that the oil level is between the upper level and lower level of the engine oil level dipstick.
    If the oil level is low, check for leakage and add oil up to the upper level of the oil level dipstick.


CHECK OIL PRESSURE

  1. Remove the engine oil pressure switch.

    1. Disconnect the connector.

    2. A145774
      Using a 24 mm deep socket wrench, remove the oil pressure switch.

  1. A145773
    Install the oil pressure gauge.

  1. Start and warm up the engine.

  1. Check the oil pressure.

    Standard:
    Engine RPM
    Oil Pressure
    Idle
    29 kPa (0.3 kgf/cm2, 4.2 psi) or higher
    3,000 rpm
    245 kPa (2.5 kgf/cm2, 33 psi) or higher

    If the oil pressure is not as specified, check the oil pump (Click here).

  1. Remove the oil pressure gauge.

  1. G036762E02
    Install the oil pressure switch.

    1. Apply adhesive to 2 or 3 threads of the oil pressure switch.

      Adhesive:
      Toyota Genuine Seal Packing Black, Three Bond 1207B or equivalent

    2. Using a 24 mm deep socket wrench, install the oil pressure switch and wait at least 1 hour for the adhesive to dry.

      Torque:
      15 N*m{ 153 kgf*cm , 11 ft.*lbf }

      NOTICE:
      Do not start the engine for at least 1 hour after installation of the switch.

    3. Connect the oil pressure switch connector.

  1. Start the engine and check for engine oil leaks.

← PRECAUTION (from Oct 2014)COMPONENTS (from Oct 2014) →