INSPECTION
Inspection · Vehicles built from Oct 2014
| REMOVE OIL PUMP RELIEF VALVE |
![]() ![]() |
Remove the plug, gasket, spring and relief valve from the timing gear case.
| INSPECT OIL PUMP RELIEF VALVE |
![]() ![]() |
Coat the relief valve with engine oil and drop it into the relief valve hole.
Check that the relief valve falls in smoothly by its own weight.
If it does not, replace the relief valve.
If necessary, replace the timing gear case.
| INSPECT OIL PUMP |
![]() ![]() |
Install the driven rotor into the timing gear case with the mark facing the cylinder block side.
Check the tip clearance.

Using a feeler gauge, measure the clearance between the drive and driven rotor tips.
- Tip clearance:
Specification
Clearance
Standard
0.06 to 0.16 mm
(0.0024 to 0.0063 in.)
Maximum
0.21 mm
(0.0083 in.)
Check the body clearance.

Using a feeler gauge, measure the clearance between the oil pump body and driven rotor.
- Body clearance:
Specification
Clearance
Standard
0.10 to 0.17 mm
(0.0039 to 0.0067 in.)
Maximum
0.20 mm
(0.0079 in.)
Check the side clearance.

Using a feeler gauge and precision straightedge, measure the clearance between the driven rotor and precision straightedge.
- Side clearance:
Specification
Clearance
Standard
0.03 to 0.09 mm
(0.0012 to 0.0035 in.)
Maximum
0.15 mm
(0.0059 in.)
| INSTALL OIL PUMP RELIEF VALVE |
![]() ![]() |
Install the relief valve and spring into the timing gear case.
Install a new gasket and plug into the timing gear case.
- Torque:
- 49 N*m{ 500 kgf*cm , 36 ft.*lbf }



