C0226/21 SFR Solenoid Circuit
Diagnostic trouble codes · Vehicles built from Jan 2017
Also covers:
- C0236/22 SFL Solenoid Circuit
- C0246/23 SRR Solenoid Circuit
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Dec 2016 from Jan 2017
DESCRIPTION
The solenoid comes on when signals are received from the ECU and controls the pressure acting on the wheel cylinders, thus controlling brake force.If any DTCs are output, the solenoid does not come on because the solenoid relay is forcibly turned off by the fail-safe function.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| C0226/21 |
Open or short circuit in SFRH or SFRR circuit continues for 0.05 seconds or more. |
|
| C0236/22 |
Open or short circuit in SFLH or SFLR circuit continues for 0.05 seconds or more. |
|
| C0246/23 |
Open or short circuit in SRRH or SRRR circuit continues for 0.05 seconds or more. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. RECONFIRM DTC |
- HINT:
- These codes are detected when a problem is identified in the brake actuator.
- The solenoid circuit is in the brake actuator.
- Therefore, solenoid circuit inspection and solenoid unit inspection cannot be performed. Be sure to check if any DTC is output before replacing the brake actuator assembly.
Clear the DTCs (Click here).
Start the engine.
Drive the vehicle at the speed of 4 mph (6 km/h) or more.
Check that the same DTCs are recorded (Click here).
- HINT:
- If a speed signal of 4 mph (6 km/h) or more is input to the skid control ECU, with the ignition switch ON and the stop light switch off, the ECU performs self-diagnosis of the motor and solenoid circuits.
- Result:
Condition
Proceed to
DTCs (C0226/21, C0236/22 and C0246/23) are output
A
DTCs (C0226/21, C0236/22 and C0246/23) are not output
B
- HINT:
- If any DTCs are output while jiggling a connector or wire harness of the brake actuator (skid control ECU), inspect and repair the connector or wire harness.
- If any DTCs are output while jiggling a connector or wire harness of the brake actuator (skid control ECU), inspect and repair the connector or wire harness.
- If the normal system code is output, slightly jiggle the connectors, wire harnesses, and fuses of the brake actuator assembly. Make sure that no DTCs are output.
- If the normal system code is output, slightly jiggle the connectors, wire harnesses, and fuses of the brake actuator assembly. Make sure that no DTCs are output.
- These DTCs may be stored due to a malfunction in the connector terminal connection, etc.
- These DTCs may be stored due to a malfunction in the connector terminal connection, etc.
|
|
||||
| A | ||
| ||
