2014-2019 Hiace · Service Manual BRAKE

DTC CHECK / CLEAR

Troubleshooting · Vehicles built from Jan 2017

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Dec 2016 from Jan 2017


DTC CHECK/CLEAR (WHEN USING SST CHECK WIRE:)

  1. C052361E48
    DTC check

    1. Using SST, connect terminals TC and CG of the DLC3.

      SST
      09843-18040  

    2. Turn the ignition switch to the ON position.

    3. Read the DTCs from the ABS warning light on the combination meter.

      HINT:
      If no code appears, inspect the TC and CG terminal circuit and the ABS warning light circuit.

      Trouble Area
      See procedure
      TC and CG terminal circuit
      Click here
      ABS warning light circuit
      Click here or Click here

    4. As an example, refer to the chart below for the blinking patterns of the normal system code and trouble codes 11 and 21.
      I042843E01

    5. The codes are explained in the code table (Click here).

    6. After completing the check, disconnect terminals TC and CG of the DLC3, and turn off the display. If 2 or more DTCs are detected at the same time, the DTCs will be displayed in ascending order.

  2. C052361E48
    DTC clear

    1. Using SST, connect terminals TC and CG of the DLC3.

      SST
      09843-18040  

    2. Turn the ignition switch to the ON position.

    3. BR03890
      Clear the DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.

    4. Check that the warning light indicates the normal system code.

    5. Remove the SST from the terminals of the DLC3.

      HINT:
      Clearing the DTCs cannot be performed by removing the battery cable or the ECU-IG NO. 1 fuse.


DTC CHECK/CLEAR (WHEN USING INTELLIGENT TESTER:)

  1. C112604E01
    DTC check

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to the ON position.

    3. Read the DTCs by following the prompts on the tester screen.

  2. DTC clear

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to the ON position.

    3. Operate the intelligent tester to clear the codes.

      HINT:
      Refer to the intelligent tester operator's manual for further details.


END OF DTC CHECK/CLEAR
  1. Turn the ignition switch to the ON position.

  2. Check that the ABS warning light goes off within approximately 3 seconds.

← DTC CHECK / CLEAR (Jan 2015 – Dec 2016)FREEZE FRAME DATA (Oct 2014 – Dec 2014) →