2014-2019 Hiace · Service Manual BODY ELECTRICAL

Entire Combination Meter does not Operate

Circuit diagnosis · Vehicles built from Oct 2014

WIRING DIAGRAM

C265646E08

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK COMBINATION METER ASSEMBLY (COMBINATION METER ASSEMBLY - BATTERY AND BODY GROUND)

  1. C240157E24
    Disconnect the combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H20-21 (E1) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    H20-1 (L) - Body ground
    Always
    11 to 14 V
    H20-2 (IG+) - Body ground
    Ignition switch ON
    11 to 14 V

Text in Illustration 
*a
Rear view of wire harness connector
(to to Combination Meter Assembly)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)


← U0100 Lost Communication with ECM / PCM "A" (+ U0129, U0151, U0182) (from Jan 2017)Speedometer Malfunction (Oct 2014 – Dec 2014) →