2014-2019 Hiace · Service Manual BRAKE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT PARKING BRAKE SWITCH ASSEMBLY
  1. Disconnect the connector from the parking brake switch.

  1. Measure the resistance between the terminal of the parking brake switch assembly and the switch body when operating the switch shaft.

    Standard resistance (Engine idling):
    Below 1 Ω

    Standard resistance (Engine stopped):
    10 kΩ or higher

    HINT:
    If the value is not as specified, replace the parking brake switch.

← INSTALLATION (from Oct 2014)PRECAUTION (Oct 2014 – Mar 2016) →