2014-2019 Hiace · Service Manual SUSPENSION & AXLE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Oct 2014


REMOVE FRONT WHEEL

INSPECT FRONT AXLE HUB RUNOUT

  1. C103109
    Using a dial indicator, check for runout on the surface of the front axle hub outside the hub bolt.

    Maximum:
    0.07 mm (0.0028 in.)

    NOTICE:
    Ensure that the dial indicator is set at right angles to the measurement surface.

    If runout exceeds the maximum, replace the front axle hub.


INSPECT FRONT AXLE HUB BEARING LOOSENESS

  1. C103108
    Using a dial indicator, check for looseness near the center of the front axle hub.

    Maximum:
    0.05 mm (0.0020 in.)

    NOTICE:
    Ensure that the dial indicator is set at right angles to the measurement surface.

    If looseness exceeds the maximum, replace the bearing.


INSTALL FRONT WHEEL

Torque:
100 N*m{ 1,020 kgf*cm , 74 ft.*lbf }

← COMPONENTS (from Oct 2014)REMOVAL (from Oct 2014) →