2014-2019 Hiace · Service Manual RESTRAINTS

SRS Warning Light does not Come ON

Circuit diagnosis · Vehicles built Oct 2014 – Dec 2014

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017

DESCRIPTION

Refer to the "SRS Warning Light Remains ON" (Click here).

WIRING DIAGRAM

Refer to the "SRS Warning Light Remains ON" (Click here).

INSPECTION PROCEDURE


1. CHECK BATTERY
  1. Measure the voltage of the battery.

    Voltage:
    11 to 14 V



NG
CHECK AND REPLACE BATTERY OR CHARGING SYSTEM
OK


2. CHECK CONNECTORS
  1. Turn the ignition switch to the LOCK position.

  1. Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.

  1. Check that the connectors are properly connected to the center airbag sensor assembly and the combination meter.

    OK:
    The connectors are connected.



NG
CONNECT CONNECTORS, THEN GO TO STEP 1
OK


3. CHECK WIRE HARNESS (SOURCE VOLTAGE OF COMBINATION METER)

  1. C109571E04
    Disconnect the connector from the combination meter.

  1. Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.

  1. Turn the ignition switch to the ON position.

  1. Measure the voltage according to the value(s) in the table below.

    Voltage:
    Tester connection
    Condition
    Specified condition
    H20-5 (B) - Body ground
    Ignition switch ON
    10 to 14 V
    H20-6 (IG+) - Body ground
    Always
    10 to 14 V

  1. Turn the ignition switch to the LOCK position.

  1. Measure the resistance according to the value(s) in the table below.

    Resistance:
    Tester connection
    Condition
    Specified condition
    H20-7 (E1) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE WIRE HARNESS
OK


4. CHECK SRS WARNING LIGHT
  1. Turn the ignition switch to the LOCK position.

  1. Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.

  1. Connect the connector to the combination meter.

  1. Connect the negative (-) terminal cable to the battery, and wait for at least 2 seconds.

  1. Turn the ignition switch to the ON position.

  1. Check the SRS warning light condition.

    OK:
    The SRS warning light does not come on.



NG
GO TO COMBINATION METER SYSTEM
OK

REPLACE CENTER AIRBAG SENSOR ASSEMBLY


← SRS Warning Light Remains ON (from Jan 2017)SRS Warning Light does not Come ON (Jan 2015 – Mar 2016) →