2014-2019 Hiace · Service Manual TRANSMISSION

DISASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. INSPECT PISTON OPERATION OF OVERDRIVE BRAKE

  1. AT08451
    Place the O/D support assembly onto the direct clutch assembly.

  1. AT08149
    Apply compressed air (392 kPa, 4 kgf/cm2, 57 psi) into the oil passage, and check that the O/D brake piston moves smoothly.


2. REMOVE OVERDRIVE BRAKE RETURN SPRING SUB-ASSEMBLY

  1. AT08444E02
    Place SST on the spring retainer, and compress the return spring with a press.
    SST
    09350-30020   (09350-07030)

  1. Remove the snap ring with a screwdriver.

  1. Remove the piston return spring.


3. INSPECT OVERDRIVE BRAKE RETURN SPRING SUB-ASSEMBLY

  1. D001246
    Measure the free length of the spring together with the spring seat.

    Standard free length:
    17.03 mm (0.671 in.)


4. REMOVE OVERDRIVE BRAKE PISTON

  1. D001432
    Place the O/D support onto the direct clutch assembly.

  1. Hold the O/D brake piston so that it does not slant, and apply compressed air (392 kPa, 4 kgf/cm2, 57 psi) into the passage to remove the O/D brake piston.

  1. Remove the O/D brake piston.

  1. D001336E02
    Remove the 2 O-rings.


5. REMOVE OVERDRIVE CLUTCH DRUM OIL SEAL RING

  1. AT08160
    Remove the 2 oil seal rings.

  1. AT08158
    Remove the thrust washer from O/D support.


6. INSPECT OVERDRIVE BRAKE CLUTCH DISC

  1. AT06454E02
    Check if the sliding surface of the disc, the plate and the flange are worn or burnt. If necessary, replace them.

    HINT:
    1. If the lining of the disc is peeled off or discolored, or even if only a part of the printed numbers is corroded, replace all discs.
    2. Before assembling new discs, soak them in ATF for at least 15 minutes.

← COMPONENTS (from Oct 2014)INSPECTION (from Oct 2014) →