2014-2019 Hiace · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. INSTALL OVERDRIVE CLUTCH DRUM OIL SEAL RING

  1. AT08151
    Coat the 2 oil seal rings with ATF.

  1. Squeeze the ends of the 2 oil seal rings together, and then install them to the starter shaft groove.

    NOTICE:
    Do not spread the ring ends more than necessary.

    HINT:
    After installing the oil seal rings, check that they rotate smoothly.

  1. AT08158
    Coat the thrust washer with petroleum jelly, and install it into the O/D support.

    HINT:
    Make sure that the lugs shapes fit into the holes on the O/D support.


2. INSTALL OVERDRIVE BRAKE PISTON

  1. D001336E02
    Coat 2 new O-rings with ATF, and install them in the O/D brake piston.

  1. AT01979
    Being careful not to damage the O-rings, and press in the brake piston into the O/D support with both hands.


3. INSTALL OVERDRIVE BRAKE RETURN SPRING SUB-ASSEMBLY

  1. AT01978
    Install the piston return spring.

  1. D001341E02
    Place SST on the spring retainer, and compress the return spring with a shop press.
    SST
    09350-30020   (09350-07030)

  1. D025625E02
    Install the snap ring with a screwdriver.

    NOTICE:
    Be sure the end gap of the snap ring is not aligned with the cutout portion of the O/D support.

    HINT:
    After assembling the O/D support assembly completely, align the position of the piston with the position shown in the illustration "A".
    Align the end gap of the snap ring as shown in the illustration "B".
    Make sure that the snap ring is not on the part of return spring to prevents the spring from coming off. Check this on 8 places.


4. INSPECT PISTON OPERATION OF OVERDRIVE BRAKE

  1. AT08149
    Place the O/D support assembly onto the direct clutch assembly.

  1. Apply compressed air (392 kPa, 4 kgf/cm2, 57 psi) into the oil passage as shown, and be sure that the O/D brake piston moves smoothly.

← INSPECTION (from Oct 2014)COMPONENTS (from Oct 2014) →