DISASSEMBLY
Removal / installation · Vehicles built from Oct 2014
| 1. INSPECT PACK CLEARANCE OF DIRECT CLUTCH |
Place the direct clutch assembly onto the O/D support assembly.

Using SST and a dial indicator, measure the direct clutch pack clearance while applying and releasing compressed air (186 to 206 kPa, 1.9 to 2.1 kgf/cm2, 27 to 30 psi).

- Pack Clearance:
- 0.40 to 0.70 mm (0.016 to 0.028 in.)
| 2. REMOVE DIRECT CLUTCH FLANGE |
Using a screwdriver, remove the snap ring from the direct clutch drum.

Remove the flange, the 4 plates and the 4 discs.
| 3. INSPECT DIRECT CLUTCH FLANGE |
Check to see if the sliding surface of the disc, the plate and the flange are worn or burnt. If necessary, replace them.

- HINT:
- If the lining of the disc is peeled off or discolored, or even if only a part of the printed numbers is corroded, replace all discs.
- Before assembling new discs, soak them in ATF for at least 15 minutes.
- If the lining of the disc is peeled off or discolored, or even if only a part of the printed numbers is corroded, replace all discs.
| 4. REMOVE DIRECT CLUTCH RETURN SPRING SUB-ASSEMBLY |
Place SST on the piston return spring and compress.

- SST
- 09350-30020
(09350-07040)
Using SST, remove the snap ring.
- SST
- 09350-30020
(09350-07070)
Remove the return spring.

| 5. INSPECT DIRECT CLUTCH RETURN SPRING SUB-ASSEMBLY |
Measure the free length of the spring together with the spring seat.

- Standard free length:
- 21.32 mm (0.839 in.)
| 6. REMOVE DIRECT CLUTCH RETURN SPRING SUB-ASSEMBLY |
Place the direct clutch drum onto the O/D support.

Hold the direct clutch piston, and apply compressed air (196 kPa, 2.0 kgf/cm2, 28.5 psi) to the O/D support to remove the direct clutch piston.
- HINT:
- Make sure the direct clutch piston is at a right angle to the drum before applying compressed air.
Using a small screwdriver, remove the 2 O-rings from the piston.

| 7. INSPECT DIRECT CLUTCH PISTON SUB-ASSEMBLY |
Check that the check ball is free by shaking the piston.

Check that the valve does not have leaks by applying low-pressure compressed air.
| 8. INSPECT DIRECT CLUTCH DRUM SUB-ASSEMBLY |
Using a deal indicator, measure the inside diameter of the clutch drum bushing.

- Maximum inside diameter:
- 53.97 mm (2.1248 in.)
