2014-2019 Hiace · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. INSTALL DIRECT CLUTCH PISTON SUB-ASSEMBLY

  1. D001453E02
    Coat 2 new O-rings with ATF, and install them in the direct clutch piston.

  1. D001354
    Be careful not to damage the O-rings, and press in the direct clutch piston into the clutch drum with both hands.


2. INSTALL DIRECT CLUTCH RETURN SPRING SUB-ASSEMBLY

  1. D001349E02
    Install the return spring.

  1. D001348E03
    Place SST on the spring retainer, and compress the return spring with a press.
    SST
    09350-30020   (09350-07040)

  1. Using SST, install the snap ring.

    SST
    09350-30020   (09350-07070)

    NOTICE:
    Be sure the end gap of the snap ring is not aligned with the spring retainer claw.


3. INSTALL DIRECT CLUTCH FLANGE

  1. AT01640E02
    Install the cushion plate.

  1. Install the 4 plates and the 4 discs.

    Install in order:
    P = Plate, D = Disc
    P - D - P - D - P - D - P - D

  1. Install the flange with the flat end facing downward.

  1. D001346
    Using a screwdriver, install the snap ring.

    NOTICE:
    Be sure the end gap of the snap ring is not aligned with the cutout portion of the direct clutch drum.


4. INSPECT PACK CLEARANCE OF DIRECT CLUTCH

  1. AT08250
    Place the direct clutch assembly onto the O/D support assembly.

  1. D029739E01
    Using SST and a dial indicator, measure the direct clutch piston stroke while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).
    SST
    09350-30020   (09350-06120)

    Pack Clearance:
    0.40 to 0.70 mm (0.016 to 0.028 in.)

    If the pack clearance is less than the limit of piston stroke, parts may have been assembled incorrectly, so check and reassemble again.
    If the pack clearance is outside the standard, select another flange.

    HINT:
    There are 8 different flanges in thickness.

    Flange thickness:
    mm (in.)
    No.
    Thickness
    No.
    Thickness
    53
    3.3 (0.130)
    57
    3.7 (0.146)
    54
    3.4 (0.134)
    58
    3.8 (0.150)
    55
    3.5 (0.138)
    60
    4.0 (0.157)
    56
    3.6 (0.142)
    62
    4.2 (0.165)

← INSPECTION (from Oct 2014)COMPONENTS (from Oct 2014) →