2014-2019 Hiace · Service Manual TRANSMISSION

DISASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. FIX FORWARD CLUTCH ASSEMBLY

  1. AT08165
    Place wooden blocks, etc., to prevent forward clutch shaft from touching the work stand, and place the O/D support on them.

  1. Place the forward clutch in the O/D support.


2. INSPECT PISTON STROKE OF FORWARD CLUTCH

  1. AT07843E02
    Using SST and a dial indicator, measure forward clutch piston stroke while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).
    SST
    09350-30020   (09350-06120)

    Piston stroke:
    0.60 to 1.00 mm (0.024 to 0.039 in.)

    If the piston stroke is outside the standard, inspect the discs.


3. REMOVE FORWARD MULTIPLE DISC CLUTCH DISC

  1. D001358
    Using a screwdriver, remove the snap ring from the forward clutch drum.

  1. Remove the flange, the 5 plates and the 5 discs.

  1. AT08177
    Remove the cushion plate.


4. INSPECT FORWARD MULTIPLE DISC CLUTCH CLUTCH DISC

  1. D001216
    Check if the sliding surface of the disc, the plate and flange are worn or burnt. If necessary, replace them.

    HINT:
    1. If the lining of the disc is peeled off or discolored, or even if only a part of the printed numbers is corroded, replace all discs.
    2. Before assembling new discs, soak them in ATF for at least 15 minutes.


5. REMOVE FORWARD CLUTCH RETURN SPRING SUB-ASSEMBLY

  1. D001274E02
    Place SST on the spring retainer, and compress the return spring with a press.
    SST
    09350-30020   (09350-07040)

  1. Using SST, remove the snap ring.

    SST
    09350-30020   (09350-07070)

  1. D001359E02
    Remove the piston return spring.


6. REMOVE FRONT CLUTCH PISTON SUB-ASSEMBLY

  1. D025661
    Place the forward clutch drum onto the O/D support.

  1. Hold the forward clutch piston by hand, apply compressed air (196 kPa, 2.0 kgf/cm2, 28.5 psi) to the O/D support to remove the forward clutch piston.

  1. Remove the forward clutch piston.

  1. AT08179
    Remove the O-ring from the forward clutch drum.


7. REMOVE FORWARD CLUTCH PISTON O-RING

  1. D001361E02
    Using a small screwdriver, remove the 2 O-rings.


8. INSPECT FRONT CLUTCH PISTON SUB-ASSEMBLY

  1. D001424
    Check that the check ball is free by shaking the piston.

  1. Check that the valve does not have leaks by applying low-pressure compressed air.


9. REMOVE INPUT SHAFT OIL SEAL RING

  1. AT08180
    Remove the 3 oil seal rings from the forward clutch drum groove.


10. INSPECT INPUT SHAFT SUB-ASSEMBLY

  1. AT08171
    Using a dial indicator, measure the inside diameter of the forward clutch drum bushing.

    Maximum inside diameter:
    24.08 mm (0.948 in.)

    If the inside diameter is greater than the maximum, replace the input shaft sub-assembly.

← COMPONENTS (from Oct 2014)INSPECTION (from Oct 2014) →