INSPECTION
Inspection · Vehicles built from Oct 2014
| INSPECT PISTON STROKE OF FORWARD CLUTCH |
Using SST and a dial indicator, measure forward clutch piston stroke while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).

- SST
- 09350-30020
(09350-06120)
- Piston stroke:
- 0.60 to 1.00 mm (0.024 to 0.039 in.)
| INSPECT FORWARD MULTIPLE DISC CLUTCH CLUTCH DISC |
Check if the sliding surface of the disc, the plate and flange are worn or burnt. If necessary, replace them.

- HINT:
- If the lining of the disc is peeled off or discolored, or even if only a part of the printed numbers is corroded, replace all discs.
- Before assembling new discs, soak them in ATF for at least 15 minutes.
- If the lining of the disc is peeled off or discolored, or even if only a part of the printed numbers is corroded, replace all discs.
| INSPECT FRONT CLUTCH PISTON SUB-ASSEMBLY |
Check that the check ball is free by shaking the piston.

Check that the valve does not have leaks by applying low-pressure compressed air.
| REMOVE INPUT SHAFT SUB-ASSEMBLY |
Using a dial indicator, measure the inside diameter of the forward clutch drum bushing.

- Maximum inside diameter:
- 24.08 mm (0.948 in.)
| INSTALL PISTON STROKE OF FORWARD CLUTCH |
Using SST and a dial indicator, measure the forward clutch piston stroke while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).

- SST
- 09350-30020
(09350-06120)
- Piston stroke:
- 0.60 to 1.00 mm (0.024 to 0.039 in.)
If the piston stroke is outside the standard, select another flange.- HINT:
- There are 8 different flanges in thickness.
- Flange thickness:
No.
Thickness
No.
Thickness
90
3.0 (0.118)
94
3.8 (0.150)
91
3.2 (0.126)
95
4.0 (0.157)
92
3.4 (0.134)
96
4.2 (0.165)
93
3.6 (0.142)
97
4.4 (0.173)
