2014-2019 Hiace · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. INSTALL INPUT SHAFT OIL SEAL RING

  1. D025664
    Coat the 3 oil seal rings with ATF.

  1. Squeeze the ends of the 3 oil seal rings together, and then install them to the forward clutch drum groove.

    NOTICE:
    Do not over-spread the ring ends.

    HINT:
    After installing the oil seal rings, check that they rotate smoothly.


2. INSTALL FORWARD CLUTCH PISTON O-RING

  1. D001365E02
    Coat 2 new O-rings with ATF, and install them on the forward clutch piston.


3. INSTALL FRONT CLUTCH PISTON SUB-ASSEMBLY

  1. AT08179
    Coat a new O-ring with ATF, and install it on the forward clutch drum.

  1. D001366
    Be careful not to damage the O-rings, and press the clutch piston into the forward clutch drum with both hands.


4. REMOVE FORWARD CLUTCH RETURN SPRING SUB-ASSEMBLY

  1. D025660E02
    Install the piston return spring.

  1. D025659E02
    Place SST on the spring retainer, and compress the return spring with a press.

    NOTICE:
    Be sure the end gap of the snap ring is not aligned with the spring retainer claw.


5. REMOVE FORWARD MULTIPLE DISC CLUTCH CLUTCH DISC

  1. AT08177
    Install the cushion plate.

  1. C116366E01
    Install the 5 plates and 5 discs.

    Install in order:
    P = Plate, D = Disc
    P - D - P - D - P - D - P - D - P - D

    HINT:
    Only the thickness of the plate on the bottom is 1.4 mm (0.055 in.) and that of the other plates is 1.8 mm (0.071 in.).

  1. Then install the flange with the flat end facing downward.

  1. AT08174
    Install the snap ring with a screwdriver.

    NOTICE:
    Be sure the end gap of the snap ring is not aligned with the cutout portion of the forward clutch drum.


6. INSPECT AND ADJUST PISTON STROKE OF FORWARD CLUTCH

  1. AT07843E02
    Using SST and a dial indicator, measure the forward clutch piston stroke while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).
    SST
    09350-30020   (09350-06120)

    Piston stroke:
    0.60 to 1.00 mm (0.024 to 0.039 in.)

    If the piston stroke is less than the limit, parts may have been assembled incorrectly, so check and reassemble again.
    If the piston stroke is outside the standard, select another flange.

    HINT:
    There are 8 different flanges in thickness.

    Flange thickness:
    No.
    Thickness
    No.
    Thickness
    90
    3.0 (0.118)
    94
    3.8 (0.150)
    91
    3.2 (0.126)
    95
    4.0 (0.157)
    92
    3.4 (0.134)
    96
    4.2 (0.165)
    93
    3.6 (0.142)
    97
    4.4 (0.173)

← INSPECTION (from Oct 2014)COMPONENTS (from Oct 2014) →