2014-2019 Hiace · Service Manual TRANSMISSION

DISASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. REMOVE PLANETARY CARRIER THRUST WASHER NO.4

  1. AT08184
    Remove the thrust washer from the 2nd brake piston.


2. INSPECT SECOND BRAKE PISTON RETURN SPRING SUB-ASSEMBLY

  1. D029781
    Using vernier calipers, measure the free length of the spring together with the spring seat.

    Standard free length:
    16.05 mm (0.6319 in.)


3. REMOVE SECOND BRAKE PISTON RETURN SPRING SUB-ASSEMBLY

  1. AT08438E02
    Place SST on the spring retainer, and compress the piston return spring with a press.
    SST
    09350-30020   (09350-07040)

    NOTICE:
    1. Stop compressing when the spring sheet is lowered to the place 1 to 2 mm (0.039 to 0.078 in.) from the snap ring groove, preventing the spring sheet from being deformed.
    2. Do not expand the snap ring excessively.

  1. Using a snap ring expander, remove the snap ring.

  1. Remove the spring retainer.

  1. AT08185
    Remove the piston return spring.


4. REMOVE SECOND BRAKE PISTON

  1. AT08196
    Hold the 2nd brake piston by hand, and apply compressed air to the 2nd brake drum to remove the 2nd brake piston.

  1. Remove the 2nd brake piston.

    HINT:
    If the piston is at an angle and cannot be removed, press down on the protruding side and apply compressed air again, or wind vinyl tape around the piston end and remove it with needle-nose pliers.

  1. Remove the 2 O-rings from the piston.


5. INSPECT DIRECT MULTIPLE CLUTCH DISC

  1. AT06455E02
    Check to see if the sliding surfaces of the disc, the plate and the flange are worn or burnt. If necessary, replace them.

    HINT:
    1. If the lining of the disc is peeled off or discolored, or even if only a part of the printed numbers is corroded, replace all discs.
    2. Before assembling new discs, soak them in ATF for at least 15 minutes.


6. INSPECT 2ND BRAKE PISTON RETURN SPRING SUB-ASSEMBLY

  1. D029781
    Using vernier calipers, measure the free length of the spring together with the spring seat.

    Standard free length:
    16.05 mm (0.6319 in.)

← COMPONENTS (from Oct 2014)INSPECTION (from Oct 2014) →