2014-2019 Hiace · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. INSTALL 2ND BRAKE PISTON

  1. AT08452
    Coat 2 new O-rings with ATF, and install them on the 2nd brake piston.

  1. Being careful not to damage the O-rings, and press the 2nd brake piston into the 2nd brake drum with both hands.


2. INSTALL SECOND BRAKE PISTON RETURN SPRING SUB-ASSEMBLY

  1. AT08185
    Install the piston return spring.

  1. Install the spring retainer.

  1. AT08438E02
    Place SST on the spring retainer, and compress the return spring with a press.

    NOTICE:
    1. Stop compressing when the spring sheet is lowered to the place 1 to 2 mm (0.039 to 0.078 in.) from the snap ring groove, preventing the spring sheet from being deformed.
    2. Do not expand the snap ring excessively.

  1. Using a snap ring expander, install the snap ring.


3. INSPECT SECOND BRAKE PISTON

  1. AT08439
    Make sure the 2nd brake piston moves smoothly when applying and releasing low-pressure compressed air to the 2nd brake drum.


4. INSTALL PLANETARY CARRIER THRUST WASHER NO.4

  1. AT08184
    Coat the thrust washer with petroleum jelly, and install it.

    HINT:
    Make sure that the cutout portions of thrust washer fit into the teeth of the spring retainer.

← INSPECTION (from Oct 2014)COMPONENTS (from Oct 2014) →