2014-2019 Hiace · Service Manual TRANSMISSION

DISASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. INSPECT PISTON STROKE OF DIRECT CLUTCH

  1. AT08250
    Place the direct clutch assembly onto the O/D support assembly.

  1. AT08166E01
    Using SST and a dial indicator, measure the direct clutch piston stroke while applying and releasing compressed air (392 to 785 kPa, 4.0 to 8.0 kgf/cm2, 57 to 114 psi).
    SST
    09350-30020   (09350-06120)

    Piston stroke:
    1.37 to 1.60 mm (0.0539 to 0.0630 in.)

    If the piston stroke is less than the limit, parts may have been assembled incorrectly, so check and reassemble again.
    If the piston stroke is outside the standard, select another flange.

    HINT:
    There are 8 different thicknesses for the flange.

    Flange thickness: 
    No.
    Thickness
    No.
    Thickness
    53
    3.3 (0.130)
    57
    3.7 (0.146)
    54
    3.4 (0.134)
    58
    3.8 (0.150)
    55
    3.5 (0.138)
    60
    4.0 (0.157)
    56
    3.6 (0.142)
    62
    4.2 (0.165)


2. REMOVE DIRECT CLUTCH

  1. AT08167
    Using a screwdriver, remove the snap ring from the direct clutch drum.

  1. Remove the flange, plates and discs.


3. INSPECT DIRECT CLUTCH FLANGE

  1. AT06454E01
    Check if the sliding surfaces of the disc, the plate and the flange are worn or burnt. If necessary, replace them.

    HINT:
    If the lining of the disc is peeled off or discolored, or even if only a part of the printed numbers is corroded, replace all discs.


4. REMOVE DIRECT CLUTCH RETURN SPRING SUB-ASSEMBLY

  1. AT08168E01
    Place SST on the spring retainer, and compress the piston return spring with a press.
    SST
    09350-30020   (09350-07040)

  1. Using SST, remove the snap ring.

    SST
    09350-30020   (09350-07070)

  1. Remove the return spring.


5. INSPECT DIRECT CLUTCH RETURN SPRING SUB-ASSEMBLY

  1. D001246
    Measure the free length of the spring together with the spring seat.

    Standard free length:
    21.32 mm (0.8394 in.)


6. REMOVE DIRECT CLUTCH PISTON SUB-ASSEMBLY

  1. AT08169
    Place the direct clutch drum onto the O/D support.

  1. Hold the direct clutch piston, and apply compressed air to the O/D support to remove the direct clutch piston.

  1. Remove the 2 O-rings from the piston.


7. INSPECT DIRECT CLUTCH PISTON SUB-ASSEMBLY

  1. AT08435
    Check that the check ball is free by shaking the piston.

  1. Check that the valve does not have leaks by applying low-pressure compressed air.


8. INSPECT DIRECT CLUTCH DRUM SUB-ASSEMBLY

  1. AT08156
    Using a dial indicator, measure the inside diameter of the clutch drum bushing.

    Maximum inside diameter:
    53.99 mm (2.1256 in.)

    If the inside diameter is greater than the maximum, replace the clutch drum.

← COMPONENTS (from Oct 2014)INSPECTION (from Oct 2014) →