INSPECTION
Inspection · Vehicles built from Oct 2014
| INSPECT PISTON STROKE OF DIRECT CLUTCH |
Place the direct clutch assembly onto the O/D support assembly.

Using SST and a dial indicator, measure the direct clutch piston stroke while applying and releasing compressed air (392 to 785 kPa, 4.0 to 8.0 kgf/cm2, 57 to 114 psi).

- SST
- 09350-30020
(09350-06120)
- Piston stroke:
- 1.37 to 1.60 mm (0.0539 to 0.0630 in.)
If the piston stroke is outside the standard, select another flange.- HINT:
- There are 8 different thicknesses for the flange.
Flange thickness: No.
Thickness
No.
Thickness
53
3.3 (0.130)
57
3.7 (0.146)
54
3.4 (0.134)
58
3.8 (0.150)
55
3.5 (0.138)
60
4.0 (0.157)
56
3.6 (0.142)
62
4.2 (0.165)
| INSPECT DIRECT CLUTCH FLANGE |
Check if the sliding surfaces of the disc, the plate and the flange are worn or burnt. If necessary, replace them.

- HINT:
- If the lining of the disc is peeled off or discolored, or even if only a part of the printed numbers is corroded, replace all discs.
| INSPECT DIRECT CLUTCH RETURN SPRING SUB-ASSEMBLY |
Measure the free length of the spring together with the spring seat.

- Standard free length:
- 21.32 mm (0.8394 in.)
| INSPECT DIRECT CLUTCH PISTON SUB-ASSEMBLY |
Check that the check ball is free by shaking the piston.

Check that the valve does not have leaks by applying low-pressure compressed air.
| INSPECT DIRECT CLUTCH DRUM SUB-ASSEMBLY |
Using a dial indicator, measure the inside diameter of the clutch drum bushing.

- Maximum inside diameter:
- 53.99 mm (2.1256 in.)
