2014-2019 Hiace · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. INSPECT DIRECT CLUTCH PISTON SUB-ASSEMBLY

  1. AT08435
    Check that the check ball is free by shaking the piston.

  1. Check that the valve does not have leaks by applying low-pressure compressed air.


2. INSPECT DIRECT CLUTCH DRUM SUB-ASSEMBLY

  1. AT08156
    Using a dial indicator, measure the inside diameter of the clutch drum bushing.

    Maximum inside diameter:
    53.99 mm (2.1256 in.)

    If the inside diameter is greater than the maximum, replace the clutch drum.


3. INSTALL DIRECT CLUTCH PISTON SUB-ASSEMBLY

  1. AT08161
    Coat 2 new O-rings with ATF, and install them on the direct clutch piston.

  1. Be careful not to damage the O-rings, and press the direct clutch piston into the clutch drum with both hands.


4. INSTALL DIRECT CLUTCH RETURN SPRING SUB-ASSEMBLY

  1. AT08443
    Install the return spring.

  1. Place SST on the spring retainer, and compress the return spring with a press.

    SST
    09350-30020   (09350-07040)

  1. Install the snap ring with SST. Be sure the end gap of the snap ring is not aligned with the spring retainer.

    SST
    09350-30020   (09350-07070)


5. INSTALL DIRECT CLUTCH FLANGE
  1. Install the 3 plates and the discs.

    Install in order:
    P = Plate D = Disc
    P - D - P - D - P - D

  1. D006569
    Install the flange with the flat end facing downward.

  1. Using a screwdriver, install the snap ring.

    NOTICE:
    Be sure the end gap of the snap ring is not aligned with the spring retainer claw.


6. INSPECT PISTON STROKE OF DIRECT CLUTCH

  1. AT08250
    Place the direct clutch assembly onto the O/D support assembly.

  1. AT08166E01
    Using SST and a dial indicator, measure the direct clutch piston stroke while applying and releasing compressed air (392 to 785 kPa, 4.0 to 8.0 kgf/cm2, 57 to 114 psi).
    SST
    09350-30020   (09350-06120)

    Piston stroke:
    1.37 to 1.60 mm (0.0539 to 0.0630 in.)

    If the piston stroke is less than the limit, parts may have been assembled incorrectly, so check and reassemble again.
    If the piston stroke is outside the standard, select another flange.

    HINT:
    There are 8 different thicknesses for the flange.

    Flange thickness: 
    No.
    Thickness
    No.
    Thickness
    53
    3.3 (0.130)
    57
    3.7 (0.146)
    54
    3.4 (0.134)
    58
    3.8 (0.150)
    55
    3.5 (0.138)
    60
    4.0 (0.157)
    56
    3.6 (0.142)
    62
    4.2 (0.165)

← INSPECTION (from Oct 2014)COMPONENTS (from Oct 2014) →