2014-2019 Hiace · Service Manual TRANSMISSION

DISASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. FIX FORWARD CLUTCH ASSEMBLY

  1. AT08165
    Place wooden blocks or similar objects to prevent forward clutch shaft from touching the work stand, and place the O/D support on them.

  1. Place the forward clutch onto the O/D support.


2. INSPECT PISTON STROKE OF FORWARD CLUTCH

  1. AT07843E01
    Using SST and a dial indicator, measure the forward clutch piston stroke while applying and releasing compressed air (392 to 785 kPa, 4.0 to 8.0 kgf/cm2, 57 to 114 psi).
    SST
    09350-30020   (09350-06120)

    Piston stroke:
    0.6 to 1.0 mm (0.023 to 0.039 in.)

    If the piston stroke is outside the standard, inspect the discs.


3. REMOVE DISC

  1. AT08176
    Using a screwdriver, remove the snap ring from the forward clutch drum.

  1. Remove the flange, the 5 plates and the 5 discs.

  1. AT08177
    Remove the cushion plate.


4. INSPECT FORWARD MULTIPLE DISC CLUTCH CLUTCH DISC

  1. AT05820E01
    Check to see if the sliding surfaces of the disc, plate and flange are worn or burnt. If necessary, replace them.

    HINT:
    If the lining of the disc is peeling off or discolored, or even if a part of the printed numbers is defaced, replace all discs.


5. REMOVE FORWARD CLUTCH RETURN SPRING SUB-ASSEMBLY

  1. AT08436E01
    Place SST on the spring retainer and compress the return spring with a press.
    SST
    09350-30020   (09350-07040)

  1. Using SST, remove the snap ring.

    SST
    09350-30020   (09350-07070)

  1. D001359
    Remove the piston return spring.


6. REMOVE FRONT CLUTCH PISTON SUB-ASSEMBLY

  1. D025661
    Place the forward clutch drum onto the O/D support.

  1. Hold the forward clutch piston by hand, and apply compressed air (196 kPa, 2.0 kgf/cm2, 28.5 psi) to the O/D support to remove the forward clutch piston.

  1. Remove the forward clutch piston.

  1. AT08179
    Remove the O-ring from the forward clutch drum.


7. REMOVE FORWARD CLUTCH PISTON O-RING

  1. D001361E01
    Using a small screwdriver, remove the 2 O-rings.


8. INSPECT FRONT CLUTCH PISTON SUB-ASSEMBLY

  1. AT08170
    Check that the check ball is free by shaking the piston.

  1. Check that the valve does not have leaks by applying low-pressure compressed air.


9. REMOVE INPUT SHAFT OIL SEAL RING

  1. AT08180
    Remove the 3 oil seal rings from the forward clutch drum groove.


10. REMOVE INPUT SHAFT SUB-ASSEMBLY
← COMPONENTS (from Oct 2014)INSPECTION (from Oct 2014) →