2014-2019 Hiace · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. INSTALL INPUT SHAFT OIL SEAL RING

  1. D025664
    Coat the 3 oil seal rings with ATF.

  1. Squeeze the ends of the 3 oil seal rings together with the wrap distance 8 mm (0.31 in.) or less, and then install them to the forward clutch drum groove.

    NOTICE:
    Do not over-spread the ring ends.

    HINT:
    After installing the oil seal rings, check that they rotate smoothly.


2. INSTALL FORWARD CLUTCH PISTON O-RING

  1. D001365E01
    Coat 2 new O-rings with ATF and install them on the forward clutch piston.


3. INSTALL FRONT CLUTCH PISTON SUB-ASSEMBLY

  1. AT08179
    Coat new O-ring with ATF, and install them on the forward clutch piston with a screwdriver.

  1. AT08442
    Being careful not to damage the O-rings, and press the clutch piston into the forward clutch drum with both hands.


4. INSTALL FORWARD CLUTCH RETURN SPRING SUB-ASSEMBLY

  1. AT08173
    Install the piston return spring.

  1. Z004543E01
    Place SST on the spring retainer, and compress the return spring with a shop press.
    SST
    09350-30020   (09350-07040)

  1. Install the snap ring with SST.

    SST
    09350-30020   (09350-07070)

    NOTICE:
    Be sure the end gap of the snap ring is not aligned with the cutout portion of the forward clutch drum.


5. INSTALL FORWARD MULTIPLE DISC CLUTCH CLUTCH DISC

  1. AT08177
    Install the cushion plate with its rounded end down.

  1. C116366
    Install the 5 plates and discs.

    Install in order:
    P = Plate D = Disc
    P - D - P - D - P - D - P - D -P - D

  1. Install the flange with the rounded edge facing downward.

    HINT:
    There are 8 different thicknesses for the flange.

    Flange thickness: 
    No.
    Thickness
    No.
    Thickness
    61
    3.0 mm (0.118 in.)
    44
    3.8 mm (0.150 in.)
    60
    3.2 mm (0.126 in.)
    42
    4.0 mm (0.157 in.)
    45
    3.4 mm (0.134 in.)
    63
    4.2 mm (0.165 in.)
    62
    3.6 mm (0.142 in.)
    64
    4.4 mm (0.173 in.)

  1. AT08174
    Using a screwdriver, install the snap ring.

    NOTICE:
    Be sure the end gap of the snap ring is not aligned with the cutout portion of the forward clutch drum.


6. INSPECT PISTON STROKE OF FORWARD CLUTCH

  1. AT07843E01
    Using SST and a dial indicator, measure the forward clutch piston stroke while applying and releasing compressed air (392 to 785 kPa, 4.0 to 8.0 kgf/cm2, 57 to 114 psi).
    SST
    09350-30020   (09350-06120)

    Piston stroke:
    0.6 to 1.0 mm (0.023 to 0.039 in.)

    If the piston stroke is outside the standard, inspect the discs.

← INSPECTION (from Oct 2014)COMPONENTS (from Oct 2014) →