REMOVAL
Removal / installation · Vehicles built Oct 2014 – Dec 2014
| 1. REMOVE TRANSMISSION OIL LEVEL GAUGE SUB-ASSEMBLY |
Remove the transmission oil level gauge sub-assembly.

| 2. DRAIN AUTOMATIC TRANSMISSION FLUID |
Remove the drain plug and gasket, and drain the ATF.

Install a new gasket and the drain plug.
- Torque:
- 20 N*m{ 205 kgf*cm , 15 ft.*lbf }
| 3. REMOVE TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY |
![]() ![]() |
Remove the 2 bolts and transmission oil filler tube sub-assembly.
Remove the O-ring from the transmission oil filler tube sub-assembly.
| 4. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY |
Remove the 14 bolts.

Remove the automatic transmission oil pan sub-assembly and automatic transmission oil pan gasket.
Examine the particles in the automatic transmission oil pan sub-assembly.
Remove all the 2 transmission oil cleaner magnets and use them to collect steel particles. Carefully look at the foreign matter and particles in the automatic transmission oil pan sub-assembly and on the 2 transmission oil cleaner magnets to determine the type of wear you will find in the automatic transmission assembly.
Steel (magnetic): bearing, gear and clutch plate wear
Brass (non-magnetic): bush wear
| 5. DISCONNECT TRANSMISSION WIRE |
Disconnect the 4 connectors from the 4 shift solenoid valves.

Remove the bolt and clamp from the transmission valve body assembly.
| 6. REMOVE TRANSMISSION WIRE |
![]() ![]() |
Remove the bolt.
Pull out the transmission wire from the automatic transmission assembly to remove it.
Remove the O-ring from the transmission wire.


