2014-2019 Hiace · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built Oct 2014 – Dec 2014

Versions by build date: Oct 2014 – Dec 2014 from Jan 2015


INSPECT GENERATOR WITH CLUTCH PULLEY

  1. A222452
    Hold the center of the generator with clutch pulley and check that the outer ring turns counterclockwise and does not turn clockwise.
    Text in Illustration 
    V100135
    Free
    V100136
    Lock
    If the result is not as specified, replace the generator with clutch pulley.


INSPECT GENERATOR BRUSH HOLDER ASSEMBLY

  1. A113754E09
    Using a vernier caliper, measure the brush length.

    Standard exposed length:
    9.5 to 11.5 mm (0.374 to 0.453 in.)

    Minimum exposed length:
    4.5 mm (0.177 in.)

    Text in Illustration 
    *a
    Length
    If the brush length is less than the minimum, replace the generator brush holder assembly.


INSPECT GENERATOR ROTOR ASSEMBLY

  1. A220305
    Check that the generator rotor bearing is not rough or worn.
    If necessary, replace the generator rotor assembly.

  1. Check the generator rotor assembly for an open circuit.

    1. A220306E03
      Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      Slip ring - Slip ring
      20°C (68°F)
      2.3 to 2.7 Ω

      Text in Illustration 
      *a
      Slip Ring
      If the result is not as specified, replace the generator rotor assembly.

  1. Check if the generator rotor assembly is grounded.

    1. A220307E02
      Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      Slip ring - Rotor core
      Always
      10 kΩ or higher

      Text in Illustration 
      *a
      Slip Ring
      *b
      Rotor Core
      If the result is not as specified, replace the generator rotor assembly.

  1. A220308E02
    Using a vernier caliper, measure the slip ring diameter.

    Standard diameter:
    14.2 to 14.4 mm (0.559 to 0.567 in.)

    Minimum diameter:
    14.0 mm (0.551 in.)

    Text in Illustration 
    *a
    Diameter
    If the diameter is less than the minimum, replace the generator rotor assembly.

← DISASSEMBLY (from Jan 2015)INSPECTION (from Jan 2015) →