2014-2019 Hiace · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Oct 2014


1. INSTALL CRANKSHAFT POSITION SENSOR

  1. A102906
    Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

  1. A102285
    Install the crankshaft position sensor with the bolt.

    Torque:
    8.5 N*m{ 87 kgf*cm , 75 in.*lbf }

    NOTICE:
    Be careful that the O-ring is not cracked or jammed when installing the crankshaft position sensor.

  1. Connect the 3 wire harness clamps.

  1. A102284
    Connect the crankshaft position sensor connector to the vacuum pipe No.1.

  1. Connect the crankshaft position sensor connector.


2. INSTALL VANE PUMP OIL RESERVOIR ASSEMBLY

  1. A102278
    Install the vane pump oil reservoir assembly with the 2 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }


3. INSTALL ENGINE UNDER COVER NO.1 (w/ Engine Under Cover No.1)

Torque:
13 N*m{ 133 kgf*cm , 10 ft.*lbf }

← INSPECTION (from Oct 2014)COMPONENTS (from Oct 2014) →