INSTALLATION
Removal / installation · Vehicles built from Jan 2017
Versions by build date: Oct 2014 – Dec 2016 from Jan 2017
| 1. INSTALL NO. 2 ECM BRACKET |
Install the No. 2 ECM bracket with the 2 screws.
- Torque:
- 3.0 N*m{ 31 kgf*cm , 27 in.*lbf }
| 2. INSTALL NO. 1 ECM BRACKET |
Install the No. 1 ECM bracket with the 3 screws.
- Torque:
- 3.0 N*m{ 31 kgf*cm , 27 in.*lbf }
| 3. INSTALL ECM |
Install the ECM, connect the 2 ECM connectors and lower the 2 levers.

- NOTICE:
- When connecting a ECM connector, make sure that dirt, water and other foreign matter is not stuck between the ECM connector and ECM.
- Make sure that the 2 levers are securely lowered.
- When connecting a ECM connector, make sure that dirt, water and other foreign matter is not stuck between the ECM connector and ECM.
Attach the 2 wire harness clamps to the No. 1 ECM bracket and No. 2 ECM bracket.
Install the 3 bolts to the ECM.
- Torque:
- 5.5 N*m{ 56 kgf*cm , 49 in.*lbf }
- NOTICE:
- Do not use an ECM that has been dropped or subjected to a strong impact.
Return the floor carpet to its original position.
| 4. INSTALL FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type) |
Perform the same procedure as above on the opposite side. (Click here)
| 5. INSTALL FRONT SEAT ASSEMBLY RH (for Low-back Seat Type) |
Perform the same procedure as above on the opposite side. (Click here)
| 6. INSTALL FRONT DOOR SCUFF PLATE RH |
| 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 8. PERFORM INITIALIZATION |
Perform initialization procedures (Click here).
- NOTICE:
- Certain systems need to be initialized after reconnecting the cable to the negative (-) battery terminal.
