Headlight Leveling ECU Power Source Circuit
Circuit diagnosis · Vehicles built from Jan 2017
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017
DESCRIPTION
This circuit detects the state of the ignition switch, and sends it to the headlight leveling ECU.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
- HINT:
- After replacing the headlight leveling ECU, initialization of the ECU is necessary (Click here).
| 1. READ VALUE USING GTS (IGNITION POWER SUPPLY) |
 |
Using the GTS, read the Data List (Click here).
HL AutoLeveling
Tester Display
|
Measurement Item/Range
|
Normal Condition
|
Diagnostic Note
|
+B
|
Ignition power supply voltage value / 0 to 19.75 V
|
11 to 14 V
|
IG ON
|
- OK:
- The display is as specified in the normal condition column.
|
NG |
 |
|
|
|
| OK |
|
 |
|
| PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
|
|
| 2. CHECK HARNESS AND CONNECTOR (HEADLIGHT LEVELING ECU ASSEMBLY - BATTERY AND BODY GROUND) |
 |
- Disconnect the A39 headlight leveling ECU connector.
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
|
Switch Condition
|
Specified Condition
|
A39-1 (IG) - Body ground
|
Ignition switch ON
|
11 to 14 V
|
Ignition switch off
|
Below 1 V
|
Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
|
Condition
|
Specified Condition
|
A39-9 (E1) - Body ground
|
Always
|
Below 1 Ω
|
Text in Illustration
*a
|
Front view of wire harness connector (to Headlight Leveling ECU Assembly)
|
Result
Result
|
Proceed to
|
OK (for LHD)
|
A
|
OK (for RHD)
|
B
|
NG
|
C
|
|
B |
 |
|
| REPLACE HEADLIGHT LEVELING ECU ASSEMBLY (Click here)
|
|
|
|
C |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| A |
|
 |
|
| REPLACE HEADLIGHT LEVELING ECU ASSEMBLY (Click here)
|
|