INSTALLATION
Removal / installation · Vehicles built from Jan 2017
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Dec 2016 from Jan 2017
| 1. INSTALL FAN & GENERATOR V BELT (w/o Air Conditioning) |
Install the V belt.

Using a bar, adjust the tension of the V belt.
Tighten the bolts A and B.
- Torque:
- Bolt A:
- 75 N*m{ 765 kgf*cm , 55 ft.*lbf }
- Bolt B:
- 18 N*m{ 185 kgf*cm , 13 ft.*lbf }
Check the tension of the V belt. (Click here)
| 2. INSTALL FAN & GENERATOR V BELT (w/ Air Conditioning) |
Install the V belt.

Tightening the bolt C, adjust the tension of the V belt.
Tighten the bolts A and B.
- Torque:
- Bolt A:
- 75 N*m{ 765 kgf*cm , 55 ft.*lbf }
- Bolt B:
- 18 N*m{ 185 kgf*cm , 13 ft.*lbf }
Check the tension of the V belt. (Click here)
| 3. INSTALL V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT NO.1 (w/ Air Conditioning) |
Install the V belt.

Tightening the bolt B, adjust the tension of the V belt.
Tighten nut A.
- Torque:
- 39 N*m{ 400 kgf*cm , 29 ft.*lbf }
Check the tension of the V belt. (Click here)
| 4. INSTALL VANE PUMP V BELT |
Install the V belt.

Using a bar, adjust the tension of the V-ribbed belt.
Tighten the bolt A and nut B.
- Torque:
- Bolt (A):
- 48 N*m{ 489 kgf*cm , 35 ft.*lbf }
- Nut (B):
- 64 N*m{ 635 kgf*cm , 47 ft.*lbf }
Check the tension of the V belt. (Click here)
| 5. INSTALL ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY |
Install the 5 bolts and engine service hole cover.
- Torque:
- 13 N*m{ 133 kgf*cm , 10 ft.*lbf }
| 6. INSTALL FRONT DOOR SCUFF PLATE RH |
| 7. INSTALL FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type) |
| 8. INSTALL FRONT SEAT ASSEMBLY RH (for Low-back Seat Type) |
| 9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 10. PERFORM INITIALIZATION |
