2014-2019 Hiace · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Oct 2014


1. REMOVE MANUAL TRANSMISSION ASSEMBLY
(Click here)

2. REMOVE CLUTCH COVER ASSEMBLY

  1. C114267E01
    Put matchmarks on the clutch cover assembly and the flywheel sub-assembly.

  1. Loosen each set bolt one turn at a time until spring tension is released.

    NOTICE:
    Do not drop the clutch disc assembly.

  1. Remove the set bolts, and pull off the clutch cover assembly.


3. REMOVE CLUTCH DISC ASSEMBLY

NOTICE:
Keep the lining part of the clutch disc assembly, the pressure plate and surface of the flywheel sub-assembly away from oil and foreign matter.


4. REMOVE FLYWHEEL SUB-ASSEMBLY

  1. A058716E01
    Fix the crankshaft with SST, then remove the 8 bolts and flywheel.
    SST
    09213-54015   (91651-60855)
    09330-00021  


5. REMOVE REAR END PLATE
  1. Remove the 2 bolts and rear end plate.


6. REMOVE FLYWHEEL HOUSING DUST SEAL
  1. Remove the flywheel housing dust seal.


7. REMOVE ENGINE REAR OIL SEAL

  1. A057267E02
    Using a knife, cut off the oil seal lip.

  1. Using a screwdriver, pry out the oil seal.

    NOTICE:
    After the removal, check that the crankshaft is not damaged. If damaged, mend it with a sandpaper (#400).

← COMPONENTS (from Dec 2017)INSTALLATION (Oct 2014 – Dec 2016) →