INSTALLATION
Removal / installation · Vehicles built from Jan 2015
Versions by build date: Oct 2014 – Dec 2014 from Jan 2015
| 1. INSTALL CAMSHAFT POSITION SENSOR |
for Intake Side:
Apply a light coat of engine oil to the O-ring of the camshaft position sensor.
Install the camshaft position sensor with the bolt.
- Torque:
- 9.0 N*m{ 92 kgf*cm , 80 in.*lbf }
- NOTICE:
- When reusing the camshaft position sensor, inspect the O-ring.
- Make sure that the O-ring is not cracked or jammed when installing the camshaft position sensor.
- When reusing the camshaft position sensor, inspect the O-ring.
Connect the camshaft position sensor connector.
for Exhaust Side:
Apply a light coat of engine oil to the O-ring of the camshaft position sensor.
Install the camshaft position sensor with the bolt.
- Torque:
- 9.0 N*m{ 92 kgf*cm , 80 in.*lbf }
- NOTICE:
- When reusing the camshaft position sensor, inspect the O-ring.
- Make sure that the O-ring is not cracked or jammed when installing the camshaft position sensor.
- When reusing the camshaft position sensor, inspect the O-ring.
Connect the camshaft position sensor connector.
| 2. INSTALL INTAKE AIR CONNECTOR |
Temporarily install the intake air connector to the throttle body assembly.
Connect the vacuum hose to the intake air connector.
Connect the No. 2 PCV hose to the cylinder head cover sub-assembly, and slide the clamp to secure the hose.
Install the intake air connector with the 2 bolts.
- Torque:
- 8.0 N*m{ 82 kgf*cm , 71 in.*lbf }
Tighten the 2 hose clamps.

- Torque:
- for clamp A:
- 5.0 N*m{ 51 kgf*cm , 44 in.*lbf }
| 3. INSTALL ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY |
Install the engine service hole cover sub-assembly with the 5 bolts.
- Torque:
- 13 N*m{ 133 kgf*cm , 10 ft.*lbf }
| 4. INSTALL FRONT DOOR SCUFF PLATE RH |
| 5. INSTALL FRONT SEAT ASSEMBLY RH |
