REMOVAL
Removal / installation · Vehicles built from Jan 2015
Versions by build date: Oct 2014 – Dec 2014 from Jan 2015
| 1. REMOVE FRONT SEAT ASSEMBLY RH |
| 2. REMOVE FRONT DOOR SCUFF PLATE RH |
| 3. REMOVE ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY |
Roll up the carpet, and remove the 5 bolts and engine service hole sub cover sub-assembly.
| 4. REMOVE INTAKE AIR CONNECTOR |
Slide the clamp and disconnect the No. 2 PCV hose from the cylinder head cover sub-assembly.

Disconnect the vacuum hose from the intake air connector.
Loosen the 2 hose clamps.
Remove the 2 bolts and intake air connector.
| 5. REMOVE CAMSHAFT POSITION SENSOR |
for Intake Side:

Disconnect the camshaft position sensor connector.
Remove the bolt and camshaft position sensor.
for Exhaust Side:
Disconnect the camshaft position sensor connector.
Remove the bolt and camshaft position sensor.

