2014-2019 Hiace · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built Apr 2016 – Dec 2016

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE FRONT SEAT ASSEMBLY RH
(Click here)

3. REMOVE FRONT DOOR SCUFF PLATE RH

4. REMOVE ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY
  1. Roll up the carpet, and remove the 5 bolts and engine service hole sub cover sub-assembly.


5. REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE

  1. A102132E01
    Remove the bolt and engine oil level dipstick guide.


6. REMOVE FAN AND GENERATOR V BELT

  1. A102135E01
    Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and decrease the tension in the fan and generator V belt. Then remove the fan and generator V belt.

    NOTICE:
    When removing the fan and generator V belt, do not use the bolt of the idle pulley.

    HINT:
    After removing the fan and generator V belt, move the tensioner upward to the maximum amount.


7. DISCONNECT COOLER COMPRESSOR ASSEMBLY
  1. Disconnect the compressor and magnetic clutch connector.

  1. A102804E02
    Remove the 4 bolts and disconnect the compressor and magnetic clutch from the engine.

    HINT:
    Disconnect the compressor and magnetic clutch with the No. 1 cooler refrigerant suction hose and No. 1 cooler refrigerant discharge hose stuck by suspended from the rope.

  1. Support the compressor and magnetic clutch securely.


8. REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET

  1. A337819
    Remove the 5 bolts and No. 1 compressor mounting bracket.


9. REMOVE CRANKSHAFT POSITION SENSOR

  1. G037913
    Disconnect the crankshaft position sensor connector and detach the 2 wire harness clamps.

  1. G037914
    Remove the bolt and crankshaft position sensor.

← REMOVAL (Jan 2015 – Mar 2016)REMOVAL (from Jan 2017) →