4.
REMOVE ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY
Roll up the carpet, and remove the 5 bolts and engine service hole sub cover sub-assembly.
5.
REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE
Remove the bolt and engine oil level dipstick guide.
6.
REMOVE FAN AND GENERATOR V BELT
Use the hexagon-shaped part indicated by the arrow in the illustration to move the tensioner pulley downward and decrease the tension in the fan and generator V belt. Then remove the fan and generator V belt.
NOTICE:
When removing the fan and generator V belt, do not use the bolt of the idle pulley.
HINT:
After removing the fan and generator V belt, move the tensioner upward to the maximum amount.
7.
DISCONNECT COOLER COMPRESSOR ASSEMBLY
Disconnect the compressor and magnetic clutch connector.
Remove the 4 bolts and disconnect the compressor and magnetic clutch from the engine.
HINT:
Disconnect the compressor and magnetic clutch with the No. 1 cooler refrigerant suction hose and No. 1 cooler refrigerant discharge hose stuck by suspended from the rope.
Support the compressor and magnetic clutch securely.
8.
REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET
Remove the 5 bolts and No. 1 compressor mounting bracket.
9.
REMOVE CRANKSHAFT POSITION SENSOR
Disconnect the crankshaft position sensor connector and detach the 2 wire harness clamps.