2014-2019 Hiace · Service Manual STEERING

INSTALLATION

Removal / installation · Vehicles built from Jan 2017


1. INSTALL VANE PUMP ASSEMBLY
  1. Install the vane pump assembly with the 2 bolts.

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }


2. CONNECT PRESSURE FEED TUBE ASSEMBLY
  1. Install a new gasket to the pressure feed tube assembly.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }


3. CONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE
  1. Connect the No. 1 oil reservoir to pump hose to the vane pump assembly and slide the hose clip.


4. INSTALL FAN AND GENERATOR V BELT
  1. Set the fan and generator V belt onto each part.

    HINT:
    When installing the fan and generator V belt, attach the fan and generator V belt to the No. 1 idler pulley sub-assembly last.

  1. While turning the V-ribbed belt tensioner assembly clockwise, remove the pin.

  1. Check that the fan and generator V belt fits properly in the ribbed grooves.

    NOTICE:
    Make sure that the fan and generator V belt is set properly on each pulley.


5. ADD POWER STEERING FLUID

6. BLEED POWER STEERING FLUID
(Click here)

7. INSPECT POWER STEERING FLUID LEAK
← REASSEMBLY (from Jan 2017)COMPONENTS (from Oct 2014) →