INSTALLATION
Removal / installation · Vehicles built Oct 2014 – Dec 2014
| 1.
INSTALL TRANSMISSION VALVE BODY ASSEMBLY |
 |
- Align the groove of the manual valve with the pin of the manual valve lever.
- Install the transmission valve body assembly with the 17 bolts.
-
Torque:
- 9.8 N*m{
100 kgf*cm
, 87 in.*lbf
}
- HINT:
- Each bolt length is indicated below.
- Bolt A: 28 mm (1.10 in.)
- Bolt B: 30 mm (1.18 in.)
- Bolt C: 36 mm (1.42 in.)
- Bolt D: 45 mm (1.77 in.)
| 2.
INSTALL OVERDRIVE BRAKE TUBE |
 |
Using a plastic-faced hammer, tap in the overdrive brake tube.
- NOTICE:
- Be careful not to bend or damage the tube.
| 3.
INSTALL VALVE BODY OIL STRAINER ASSEMBLY |
 |
Install 3 new gaskets to the valve body oil strainer assembly.
Install the valve body oil strainer assembly with the 3 bolts.
-
Torque:
- 5.4 N*m{
55 kgf*cm
, 48 in.*lbf
}
| 4.
CONNECT TRANSMISSION WIRE |
 |
(Click here)