INSPECTION
Inspection · Vehicles built Oct 2014 – Dec 2014
| INSPECT FRONT OIL PUMP BODY SUB-ASSEMBLY |
Using a caliper gauge, measure the inside diameter of the front oil pump body sub-assembly bush.

- Maximum diameter:
- 38.19 mm (1.50 in.)
| INSPECT STATOR SHAFT ASSEMBLY |
![]() ![]() |
Using a caliper gauge, measure the inside diameter of the stator shaft assembly bush.
- Maximum diameter:
- 23.11 mm (0.910 in.) for front and rear side
| INSPECT CLEARANCE OF FRONT OIL PUMP BODY |
Push the front oil pump driven gear to one side of the body.

Using a feeler gauge, measure the clearance.
- Standard body clearance:
- 0.07 to 0.15 mm (0.00276 to 0.00590 in.)
- Maximum body clearance:
- 0.3 mm (0.0118 in.)
Using a feeler gauge, measure the tip clearance between the front oil pump driven gear teeth and front oil pump drive gear teeth.

- Standard tip clearance:
- 0.11 to 0.14 mm (0.00433 to 0.00551 in.)
- Maximum tip clearance:
- 0.3 mm (0.0118 in.)
Using a straightedge and feeler gauge, measure the side clearance of both gears.

- Standard side clearance:
- 0.02 to 0.05 mm (0.000788 to 0.00196 in.)
- Maximum side clearance:
- 0.1 mm (0.00394 in.)
If necessary, replace the drive and driven gears with gears of a different thickness.- HINT:
- There are 5 different thicknesses for the front oil pump drive gear and front oil pump driven gear.
- Front Oil Pump Drive Gear Thickness:
Part No.
Mark
Thickness
35321-22020
1
17.235 to 17.244 mm (0.6786 to 0.6788 in.)
35321-22030
2
17.245 to 17.254 mm (0.6790 to 0.6792 in.)
35321-22040
3
17.255 to 17.265 mm (0.6794 to 0.6797 in.)
35321-22050
4
17.266 to 17.275 mm (0.6798 to 0.6801 in.)
35321-22060
5
17.276 to 17.285 mm (0.6802 to 0.6805 in.)
- Front Oil Pump Driven Gear Thickness:
Part No.
Mark
Thickness
35322-22020
1
17.235 to 17.244 mm (0.6786 to 0.6788 in.)
35322-22030
2
17.245 to 17.254 mm (0.6790 to 0.6792 in.)
35322-22040
3
17.255 to 17.265 mm (0.6794 to 0.6797 in.)
35322-22050
4
17.266 to 17.275 mm (0.6798 to 0.6801 in.)
35322-22060
5
17.276 to 17.285 mm (0.6802 to 0.6805 in.)
| INSPECT OIL PUMP DRIVE GEAR ROTATION |
Place the oil pump assembly on the torque converter assembly.

Check that the drive gear rotates smoothly.
Remove the oil pump assembly from the torque converter assembly.

